Search results

Have you tried adding a gasoline additive that dries out moisture in the fuel tank? Most of those will also clean the fuel system.

Congratulations on the new Telluride. I've had mine for about 8 months. I did my first oil change at 1,500 miles, my second one at 5,000 and plan to do it every 5,000. I had the dealer turn on the functionality that allows me to track my service at my own intervals instead of the pre-set...

You need to just lightly touch the rectangle indentation on the front exterior door handles to lock them. To unlock, you need to touch the interior of the back part of the handle (it is slightly ribbed with a little light at the touch point) and that should unlock them. If you have programmed...

monroneylabels.com/

I love my Telluride!

This is from a 2023 wiring diagram. It shows the license plate lights are from the IPS system. Not sure where that is located, but hopefully gives you a clue. It seems to indicate that there is not a fuse.

I only use Bosch, too. I found a rear one on Amazon. Lots of comments that it fits a Telluride perfectly and it fit mine. BOSCH H326 Rear Wiper Blade; 13" - Single

MY guess is that it is the external temperature sensor, as that's where they're usually located.

You have to climb in the back and there is a manual release at the bottom of the tailgate. You put your key into it and slide it to manually open.

It is above the threads in a groove designed for the O-Ring. Please remember to coat the full O-Ring with engine oil. I hope that helps!

Just to be sure - are you putting the O-Ring in the right position? Also, is there any impediment where the body of the filter cover connects with the engine? Did you coat the O-ring with engine oil? Tightening torque : 31.4 - 38.2 N·m (3.2 - 3.9 kgf·m, 23.1 - 28.2 lb·ft)

I had the same question and found the answer. You buy whatever brake controller works best for your needs and this harness connects to the brake controller with the 4 bare wires and the harness plugs in under the left hand side of the dash. Many people mount their brake controller to the fuse...

Mine has updated twice since I purchased it in late March. Both times it alerted me that an update was available and that I would lose access for 20 minutes or so while the update was applied and gave me the option of delaying it or starting it then. Both went very smooth and there was a note...

My favorite is from Belkin - Magnetic Car Vent Mount. You can buy it with or without a charge cable on many sites. I've had a couple of them in two different cars and they work great.